Wireless Connectivity
Controlant wireless devices have up to 400m range in open air. The communication frequency channels are placed around 860MHz for Europe.
Open Air
The range in open air depends on various factors, including:
1. Mounting and antenna orientation
2. Proper assembly and selection of antennas.
3. Gain of antennas at the communication frequency.
4. Disturbance on communication frequencies caused by electronic devices - both low and high current devices.
5. Disturbance on communication frequencies caused by other wireless devices which are using the same or similar communication frequency.
Indoor Use
Wireless range is significantly affected by occlusion of objects. The range of wireless devices indoor depends on various factors, including:
1. The building materials used in walls and ceilings.
2. Objects which occlude the straight path of the signal
3. Proper assembly and selection of antennas.
4. Gain of antennas at the communication frequency.
5. Disturbance on communication frequencies caused by electronic devices - both low and high current.
6. Disturbance on communication frequencies caused by other wireless devices which are using the same or similar communication frequency.
In the following chapters, special issues are addressed and solutions proposed. The purpose of this text is to give an introduction to the possible issues which can arise with wireless communication and solution to those issues.
Controlant offers various accessories which can be used to optimize quality of wireless communication – including various antennas, extension cords etc.
Mounting Orientation
All Controlant equipment can be mounted in any orientation. However, mounting the device according to recommendations may have positive effects on wireless communication range. The default quarter- and half-wave antennas which the Controlant devices come equipped with by-default get the most gain if they are parallel.
Table 1: Shows the different orientation of loggers and transceivers and how good each setup is in terms of signal quality.
Environmental factors
Various environmental factors can affect on the communication range of the wireless system. Below is a description of a few issues which can arise when using wireless communication in different environments
Indoor use
Indoor use can reduce the signal strength. If the path between a transceiver and a wireless logger is closed off by walls, the signal strength might be reduced. Signal strength reduction varies, depending on the building material and thickness of walls.
The general rule is that the thicker the wall the greater reduction in signal strength. Table 2 shows the relative reduction in signal strength for different building materials. The setup is shown in picture 1.
Picture 1: Indoor use of wireless transceiver and wireless logger.
Wall material | Relative Signal Reduction |
Metallic (Aluminum, iron etc.) | Maximum reduction |
| Concrete with iron binding | Very High reduction |
Concrete | High reduction |
Gypsum | Average reduction |
Plastic/Wood | Low reduction |
Table 2: Relative reduction in signal strength for different building materials.
Best orientation | Not optimal orientation | Not optimal orientation | Bad orientation |
|
|
|
Table 1: Shows the different orientation of loggers and transceivers and how good each setup is in terms
of signal quality.